Configure a Circuitless IPv6 Interface
Before you begin
Change the VRF instance as required to configure a Circuitless IPv6 interface on a specific VRF instance.
About this task
You can use a circuitless IPv6 (CLIPv6) interface to provide uninterrupted connectivity to your system.
Procedure
- In the navigation pane, expand Configuration > IPv6.
- Select IPv6.
- Select the Circuitless IP tab.
- Select Insert.
- In the Interface field, assign a CLIP interface number.
- Type the IPv6 address and prefix length.
- Select Insert.
Circuitless IPv6 Field Descriptions
Use the data in the following table to use the Circuitless IPv6 tab.
|
Name |
Description |
|---|---|
|
Interface |
Specifies the interface to which this entry applies. |
|
Addr |
Specifies the IPv6 address to which this entry applies. |
|
AddrLen |
Specifies the prefix length value for this address. You cannot change the address length after you create it. You must provide this value to create an entry in this table. |
|
Name Note:
This field does not apply to all hardware platforms. |
Specifies the name assigned to the IPv6 CLIP address. |